Mounting LED strips can be a straightforward process. Here are some general steps to follow:

1. Plan your layout — Determine where you want to mount the LED strips and measure the length of the area to be covered. Cut the LED strips to the appropriate length if necessary.

2. Clean the surface — Use rubbing alcohol or a similar cleaning agent to remove any dirt, grease, or dust.

3. Peel the adhesive backing — Be careful not to touch the adhesive with your fingers, as this can reduce its stickiness.

4. Press firmly into place — Align the LED strip with the surface and press firmly to secure it. For a stronger hold, you can use mounting clips or brackets. Browse our connectors and mounting accessories.

5. Repeat for remaining sections — Make sure to align each section correctly and leave enough space between sections to allow for bending and connecting.

6. Connect to power — Connect the LED strips to a compatible power supply or dimmable driver, following the instructions. Test the LED strips to ensure they are working correctly.

7. Secure with heat if needed — If necessary, use a heat gun or hair dryer to warm up the adhesive and help it adhere better to the surface.

Remember to handle LED strips with care to avoid damaging the delicate components. Always use a power supply that matches the voltage and wattage requirements of your LED strips. Not sure which driver to choose? Use our LED System Builder to find a compatible setup for your project.