I'm still in the process of installing the full roll in my pantry cabinets, but so far the lights are excellent. Really good natural color, not glaring white at all. They have been easy to work with, though I do wish the polarity marks were printed a little larger. If you doing a lot of cutting and splicing, watch your polarity! It's not obvious if you haven't worked with LED strips before, but just cut straight across, down the middle of any of the copper pads, and you can terminate or join them by soldering wires or using the little plastic compression connectors or whatever you like.
The 3M tape on the back sticks well so far to the aluminum channels I'm putting them in. Powered by some decent 24V drivers and PWM dimmers, and I've had excellent performance from these lights. No flickering or continuity problems or variations in color temp or anything along the strip. All very consistent, very bright, with good diffusion, even before I put them behind another plastic diffuser. It takes time and patience to do it this way, but I dig the results.